Place of Origin: | Guangdong, China |
Brand Name: | ShengHui |
Certification: | SGS |
Model Number: | SHMMCW-01 |
Minimum Order Quantity: | 1 Roll |
---|---|
Price: | USD 200/ Roll |
Packaging Details: | 1.52*18m |
Delivery Time: | 5-7 days |
Supply Ability: | 200,00 Rolls/Month |
Face Film:: | Polymeric Calendered Vinyl Film | Face Film Thickness:: | 4.8 MIL (120 µm) |
---|---|---|---|
Surface Finish:: | Matte Metallic | Adhesive Type:: | Clear Removable Acrylic Adhesive |
Adhesive Thickness:: | 30 µm | Release Liner:: | PET Release Liner/Air-Egress PE-coated Paper Liner |
Thickness:: | 60 µm/140gsm | Max Durability:: | Up To 5 Years |
High Light: | Slidable Matte Metallic Blue Vinyl Wrap,Crystal Matte Metallic Blue Vinyl Wrap,Crystal metallic blue vinyl roll |
Product Name: Air Release Slideable Matte Crystal Blue Metallic Car Wrap Film
Product Description:
Product Specfications:
1. Face Film | Type: | Polymeric Calendered Vinyl Film | Thickness: | 120 µm |
Surface Finish: | Matte | Color: | Matte Metallic | |
2. Adhesive | Type: | Clear Removable Acrylic Adhesive | ||
Thickness: | 30 µm | Color: | Clear | |
3. Liner | Type: | Air-Egress PE-coated Paper Liner | Thickness: | 140gsm |
4. Max Durability | Up to 5-7 years | |||
5. Product Size | Width | Length | ||
(metric/m) | (Imperial/inch) | (Metric/m) | (Imperial/yard) | |
1.27 | 50 | 18 | 20 | |
1.52 | 60 | 23 | 25 | |
Notice: There is a Minimum Order Requirement for Special Product Size. |
Product Features:
Product Application:
■ Buses ■ Vehicle advertising
■ Trailers ■ Emergency Vehicles
Advantages of Applying Car Wrap Film:
FAQs:
Actually, car wrap can protect your paint because it blocks damaging ultraviolet light. When you remove it, the original finish will be intact.
Depending on the quality of the wrap, type of vinyl wrap, care taken during installing, care for installation, and environmental factors, car wraps can last from three to ten years.
1. Use your fingernail or plastic scraper to pull the wrap from the edges of the entire panel. It’s going to look gnarly, but it’ll all be gone in a few minutes.
2. Use the heat gun to evenly heat the surface of the wrap to about 120 °F (50 °C). This will loosen the adhesive so you can pull it off. Use a non-contact infrared thermometer to confirm you aren’t overheating, which can lead to excessive adhesive residue left on the surface.
3. Pull the wrap away from the edges at a steep angle, pulling the wrap back on itself at 15 to 20 degrees. When the wrap gets hard to pull, reheat and start pulling again.
4. Finally, use Turtle Wax Label & Sticker Remover or Bug & Tar Remover to remove any adhesive residue from the surface of the panel.
Hand washing is best for vinyl wraps, but brushless or touchless car washes can be just as safe. You can even use a pressure washer if you’re gentle.
Contact Person: Drew zhu
Tel: +8613533241184